Adjusting Flow To Hot And Cold Sources For Shower Rheem RTE 13 4 GPM Tankless Electric Water Heater Review

You are searching about Adjusting Flow To Hot And Cold Sources For Shower, today we will share with you article about Adjusting Flow To Hot And Cold Sources For Shower was compiled and edited by our team from many sources on the internet. Hope this article on the topic Adjusting Flow To Hot And Cold Sources For Shower is useful to you.

Rheem RTE 13 4 GPM Tankless Electric Water Heater Review

The Rheem RTE 13 4 GPM Tankless Electric Water Heater is the ideal hot water heater for low consumption needs. Fully capable of handling a single point of use at a time, this water heater will deliver 4 gallons of hot water per minute to your shower, kitchen sink, workshop, boat, or anywhere you need instant hot water.

The Rheem RTE 13 4 GPM Tankless Electric Water Heater is an indoor electric hot water heater. For optimum benefit, install the unit as close as possible to the point of use, i.e., under a sink or next to a shower stall, as the colder the water is from the heat source, the cooler it will be.

At 4 gallons per minute this water heater meets average needs; After a long day at work enjoy a hot shower in the comfort of knowing there is enough water to wash away the worst dirt and grime. See typical flow rates below:

Application flow rate in GPM at 60 PSI

Typical shower 2.0 GPM

A typical bath tub faucet is 2.5 GPM

Bathroom Vanity Sink Faucet 1.0 GPM

Kitchen sink faucet 1.5 GPM

Washing machine 2.0 GPM

Setting the water temperature

It is important to understand how the temperature settings on your water heater work. The actual thermostat is set at the factory lowest setting and the temperature range within that setting is controlled by the user with the control knob. Setting the thermostat to the lowest temperature is a safety feature and helps ensure that children, the disabled and the elderly do not accidentally suffocate themselves when turning on the hot water.

Additional benefits of keeping the thermostat temperature low are less energy costs to heat water and, less water is wasted because you don’t need to add cold water to reduce leakage. Think energy efficiency!

Temperature time to produce a severe burn

120°F over 5 minutes

125°F 11/2 to 2 minutes

130°F for about 30 seconds

135°F for about 10 seconds

140°F less than 5 seconds

145°F less than 3 seconds

150°F for about 11/2 seconds

155°F for about 1 second

Table courtesy of Shriners Burn Institute

Features:

• Compact design

• Self-adjusting temperature control

• 4 GPM continuous hot water

• LEDs indicate active components and standby mode

• Standard 1/2″ water connection

• Rugged brass/copper heat exchanger

• Electric

Details

• Weight 8lbs

• Width 10 inches

• Depth 2 inches

• Length 7 inches

• 240 Volt – 13KW

• 4.0 GPM maximum flow rate

guarantee

• Parts Warranty: 1 year

• Heat Exchange Warranty: 10 years

Customer feedback

If you’re in the habit of researching a product before buying it, you’ll realize that often one customer will rave about a product and say it’s the best thing since sliced ​​bread, while another will rave about the same product and say it’s not. work That’s why it’s always important to know what your own needs are and if the product can meet those needs.

Many users are thrilled with their Rheem RTE 13 4 GPM Tankless Electric Water Heater and use it for deer lots, small washing machines, showers and kitchen sinks. The water flow meets their expectations and the water temperature is consistently warm.

Some users report low water temperatures and faulty units; This is inevitable in any water tank, if the tank is far from the point of use and if the lines delivering the water are not sufficiently pressurized, there will be problems in maintaining a consistent temperature.

If a bathroom has a hot water tank upstairs, you may need to run the tap for a few minutes in the basement suite before you get the hottest water. A lot of water is wasted when you run the faucet, and that’s why tankless hot water heaters save you money.

Installing the Rheem RTE 13 4 GPM Tankless Electric Water Heater under the sink in a basement suite ensures you have hot water when you turn on the tap; Do not wash with cold water in the drain while you wait for hot water. Save money on your water bill and electricity bill by using the water and hot water you need.

Finally, make sure you know the average ground temperature in your area and find a Rheem tankless hot water heater to meet your conditions.

Video about Adjusting Flow To Hot And Cold Sources For Shower

You can see more content about Adjusting Flow To Hot And Cold Sources For Shower on our youtube channel: Click Here

Question about Adjusting Flow To Hot And Cold Sources For Shower

If you have any questions about Adjusting Flow To Hot And Cold Sources For Shower, please let us know, all your questions or suggestions will help us improve in the following articles!

The article Adjusting Flow To Hot And Cold Sources For Shower was compiled by me and my team from many sources. If you find the article Adjusting Flow To Hot And Cold Sources For Shower helpful to you, please support the team Like or Share!

Rate Articles Adjusting Flow To Hot And Cold Sources For Shower

Rate: 4-5 stars
Ratings: 4155
Views: 44123913

Search keywords Adjusting Flow To Hot And Cold Sources For Shower

Adjusting Flow To Hot And Cold Sources For Shower
way Adjusting Flow To Hot And Cold Sources For Shower
tutorial Adjusting Flow To Hot And Cold Sources For Shower
Adjusting Flow To Hot And Cold Sources For Shower free
#Rheem #RTE #GPM #Tankless #Electric #Water #Heater #Review

Source: https://ezinearticles.com/?Rheem-RTE-13-4-GPM-Tankless-Electric-Water-Heater-Review&id=7002194

Related Posts